It is still a great challenge for semiconductor based-devices to obtain a large magnetoresistance (MR) effect under a low magnetic field at room temperature. In this paper, the photoinduced MR effects under different intensities of illumination at room temperature are investigated in a semi-insulating gallium arsenide (SI-GaAs)-based Ag/SI–GaAs/Ag device. The device is subjected to the irradiation...
The process to decrease the dislocation density in 3-inch Fe-doped InP wafers is described. The crystal growth process is a conventional liquid encapsulated Czochralsky (LEC) but thermal shields have been added in order to decrease the thermal gradient in the growing crystal. The shape of these shields has been optimized with the help of numerical simulations of heat transfer and thermomechanical ...
Highly tensile-strained sub-monolayer Ge nanostructures on GaSb have been grown by molecular beam epitaxy and studied by ultrahigh-vacuum scanning tunneling microscopy. Four different coverage rates of Ge nanostructures on GaSb are achieved and investigated. It is found the growth of Ge on GaSb follows 2D growth mode. The crystal lattice of the sub-monolayer Ge nanostructures is coherent with that...
This paper proposes a new three-dimensional (3D) photolithography technology for a high-resolution micropatterning process on a fiber substrate. A brief review on the lithography technology of the non-planar surface is also presented. The proposed technology mainly comprises the microfabrication of the 3D exposure module and the spray deposition of thin resist films on the fiber. The 3D exposure m...
The density and light-scattering intensity of oxygen precipitates in CZ silicon crystals are measured by IR light-scattering tomography. The numerical data clarified through the measurements are discussed in relation to the amount of precipitated oxygen. The results obtained here correspond well with the theoretical analysis that oxygen precipitates cause light to scatter. The information obtained...
To realize high-performance silicon carbide (SiC) power devices, low-resistance ohmic contacts to p-type SiC must be developed. To reduce the ohmic contact resistance, reduction of the barrier height at metal/SiC interfaces or increase in the doping concentration in the SiC substrates is needed. Since the reduction of barrier height is extremely difficult, the increase in the Al doping concentrati...
In this paper, using a fully-coupled, three-dimensional electro-thermal device simulator, we study the mechanism of efficiency degradation at high current operation in planar GaN-based light emitting diodes (LED). In particular, the improvement of the efficiency degradation using thicker conductive GaN substrates has been demonstrated. First, it is found that local Joule heating inside thin conduc...
X-ray topographic and chemical etching examination of Si:Ge single crystals containing 1.2 at% and 3.0 at% Ge, together with precise lattice parameter measurements, was performed. Diffraction contrasts in the form of concentric `quasi-circles' (striations), probably due to the non-uniform distribution of Ge atoms, were observed in projection topographs. The etching patterns reveale...